Octopus V1.1 getting the USB Serial ID

[PFarm]

How do you get the USB serial ID when the Octopus has been flashed with the USB can bridge?

When using ls /dev/serial/by-id only the Klipper Expander board shows up.

 

But when you look up devices under USB it sees the Octopus board.

Edited March 13 by PFarm

[mvdveer]

You won't get a USB serial but a UUID as it has been flashed with CAN, so no longer a serial device but a canbus device.

~/klippy-env/bin/python ~/klipper/scripts/canbus_query.py can0

 

[PFarm]

yeah duhh figured it out after posting.

[PFarm]

@mvdveer thanks for clarifying my error in the above post. I've been trying to flash the Mellow SB 2040 V3 with Klipper for the last two days. The toolhead is in Katapult mode (led is flashing) but I cannot get the UIID for Katapult. I've check that I see 60 ohms at the RJ connector unplug it at the RJ connector and get 120 ohm from the toolhead. Double checked that Katapult is compiled correctly what am I missing?

Edited March 15 by PFarm

[mvdveer]

Is the board in Klipper Can Mode?

[PFarm]

2 hours ago, mvdveer said:

Is the board in Klipper Can Mode?

The Octopus or the SB2040? Klipper Can Mode = Klipper has the UIID for the Octopus. I tried stopping Klipper service.

Edited March 14 by PFarm

[mvdveer]

The SB2040 - has two dip switches to set it to can bus for klipper

[PFarm]

yes it in Klipper mode

[PFarm]

@mvdveer Thanks was trying to flash it with everything connected to the SB2040 unplugged everything and I got it flashed with Klipper.

Edited March 15 by PFarm