Pi/CB1 how to switch HDMI ports?..

[Chuck_Snow]

You know those days where your thinking I'm tired I should lie down, No not yet just this one last part..

Does any know how and if I can Switch the HDMI0 to HMDI1  number 0 had an Accident and number 1 doesn't show any thing?..

BTT Pi/CB1  

I had it plug in it was great then. I thought hey let put that fan in whit  the Bracket I printed from Steve's Builds tried to snap it in and crack rip it right off the board

it a Sad day every thing wad going  so well on the Mercury One G Zero build Flash the board got CanBus in flash the EBB36, went trough a setup check even did the extruder 

and probe offsets just needed a few things to finish Zoffset calibration, and calibrate the Bed for the First Print, and switch the new HDMI cable..

Well that part did not go well 

Edited June 6, 2023 by Chuck_Snow

[claudermilk]

6 hours ago, Chuck_Snow said:

You know those days where your thinking I'm tired I should lie down, No not yet just this one last part..

Yes, yes I do. I've learned to listen to the first voice and tell the second one to shut up.

[PFarm]

Do you have a soldering station with a hot air gun? Could be soldered back in place by adding solder to the pads and reflowing it with the hot air gun. Have you checked the CB1 config file and see if it's possible?

Edited June 6, 2023 by PFarm

[Chuck_Snow]

I did a lot of searching there was this one util but I cant seam to find an easy way to install it and any thing else just does nt seam to work because of the Version on the PI is a little different then other version out there. I mean I could run it head less but it make it a little more Difficult for the Calibration, Z, and bed mesh I don't know all the syntax off by heart for the Command line.. sigh it $32 to replace the adapter Pi4B board..

But I did get my BTT Pi v1.2 whit the U2C hat and 2 U2C boards I did nt notice that I click 2 i nthe cart so back up parts it is ..

I might flash and hook up the Pi v1.2 to try it out and order a new adapter at some point, I mean I did buy the Pi v1.2 for back just didn't think I would need it so soon lol.

Or maybe see if one old TFT displays might work.,

I do have a great Solder Iron and heat gun but not a proper reflow heat gun

Edited June 7, 2023 by Chuck_Snow

[Chuck_Snow]

Well for the Time being I install my BTT PI v1.2 just swapped the SD Card, plugged every thing back in  Tada it was like it had all ways been there didn't have to mod any thing.

now just need to finish up the Z Calibration, Bed leveling and get that first print off.