Jump to content

General Discussion

Have something to discuss or talk about? If it is Voron related post it here!

582 topics in this forum

  1. Picked up a Milo V1.5 Kit...

    By Penatr8tor,
    • 14 replies
    • 617 views

  2. Please help me out !!! or point me to solution 1 2

    By Scorpioo42,
    • 34 replies
    • 1.1k views

  3. Goodbye Cartographer [CLOSED]

    By mvdveer,
    • 23 replies
    • 2k views

  4. Voron Phoenix - New in Voron Development

    By mvdveer,
    • 10 replies
    • 27.9k views

  5. USB->SPI STM32_Mini12864 + Bigtreetech mini 12864 v2 = black display

    By pasha4ur,   
    • 7 replies
    • 2.3k views

  6. anyone using G2E-Filametrix from IRTrail

    By therm_virtual0y,
    • 0 replies
    • 552 views

  7. Cartographer update

    By mvdveer,
    • 1 reply
    • 587 views

  8. BTT PiTFT43 v2.1 install help

    By quad121,
    • 2 replies
    • 286 views

  9. Crowsnest Pi cam with Raspi SBC setup quirk

    By kenjesse_75,
    • 6 replies
    • 14.1k views

  10. Voron 01 Extruder temp problem

    By kenjesse_75,
    • 11 replies
    • 339 views

  11. Armoured Turtle modular AMS

    By xyleth,
    • 21 replies
    • 9.8k views

  12. After software update...nothing works anymore (cartographer)

    By Casatec,
    • 4 replies
    • 999 views

  13. "Pin 'gpio26' is not a valid pin name on mcu 'mcu' error message

    By Casatec,
    • 2 replies
    • 523 views

  14. Printing TPU

    By mvdveer,
    • 14 replies
    • 1.2k views

  15. Fan confusion

    By kharrisma,
    • 20 replies
    • 2k views

  16. Now For Something Completely Different

    By claudermilk,
    • 6 replies
    • 422 views

  17. USB or CAN upgrade path?

    By RainerBoden,
    • 14 replies
    • 1.9k views

  18. Thin, Spotty Lines

    By BrentW,
    • 10 replies
    • 479 views

  19. LDO VORON Distributors / Resellers

    By Demosth,   
    • 3 replies
    • 5.2k views

  20. I'm back - Update/s

    By mvdveer,
    • 10 replies
    • 451 views

  21. MCU disconnects mid-print

    By rokapet,
    • 11 replies
    • 1.1k views

  22. VORON V2.4 CW2 Problem Help

    By hadores,
    • 4 replies
    • 418 views

  23. Put some holes under your print to avoid warping.

    By PorcoMaster,
    • 14 replies
    • 758 views

  24. Editing G code not working

    By Jason D,
    • 1 reply
    • 403 views

  25. Looking for Guidance on the Best FDM Configurations for High-Resolution Prints

    By dijede4287,
    • 1 reply
    • 572 views
×
×
  • Create New...